LINN AXIS z LINN BASIK PLUS ročko

Prekrasen, iz ugledne družine gramofonov LINN, optično in tehnično brezhiben gramofon, prodam. Na našem prostoru ne tako pogost, a vendar odličen izdelek. Čisto vsak detajl na temu izdelku je premišljen in vrhunsko izdelan z namenom po popolnem zvoku. Gre za pravi HiEnd izdelek, ki vam bo dolgo služil in nudil obilo užitka pri poslušanju vaših plošč. Poleg obstoječega jermena, (starega samo 1 leto!!), dobite zraven še enega čisto novega.Ta gramofon je eden od redkih, ki je vreden svoje cene!
Gre za manualni gramofon na jermenski pogon in zato je praktično neslišnega delovanja z izjemno dobro ročko, ki izredno natančno sledi utorom na plošči.

Prodaja se z NOVO Ortofon 2M Red odjemno dozo (kupljena 08.02.2024 - samo montirana in 15 min testiranja zaradi pravilne nastavitve!!)

CENA BREZ odjemne doze SAMO 550 eur !!

Oglejte si še moje ostale oglase. Hvala.

TEST: https://www.hifi-classic.net/review/linn-axis-140.html

PRODUCT INFORMATION:
The Axis is a precision built, twin speed (33.3 rpm and 45 rpm) transcription turntable. It is
mounted in a black veneered medite plinth, with a dark grey top-board and equipped with a
moulded, hinged dustcover.
Platter
12” diameter (305mm) aluminium diecast and accurately machined on all matching and visible
surfaces. Weight approximately 1.5kg. The platter is supplied with a felt mat.
Bearing
Single point system running in an oil bath. The thrust pad which must support the weight of
the platter on a single point is top grade steel, machined, hardened, ground and lapped to a
mirror finish.
Motor
24-pole precision synchronous low noise, high torque motor. Fully shielded and mechanically
isolated from the main bearing assembly by resilient mounting and a damped, uniquely
designed suspension system.
Speeds
33.3 rpm and 45 rpm. Speed accuracy =0.1%
Motor Power Supply
Linn-designed 2-speed electronic ‘Class A’ power supply incorporating a stall detect circuit.
This monitors the load on the motor from start-up and reduced the power supply to the motor
once the correct speed has been achieved. It will also increase the power to the motor as
required. When this happens the relevant LED on the switch will brighten to show increased
power, and dim once power is reduced. Easily changed (internally) from 110V to 240V and
will run on 50Hz or 60Hz without modification.
Suspension
Three silicone, custom moulded rubber mounts, providing isolation for both the turntable/arm
from the motor/plinth, and the feet from the plinth. Easily adjusted to keep record platform
level.
Drive
Flat, precision ground neoprene rubber belt driven by a concentric drive pulley; concentricity
0.01mm.
Top-plate
Heavy medite wood, laminated on both sides.
Power Consumption
8 Watts
Dimensions
W 445mm x D 349mm x H 140mm
With lid open 400mm high